DS1305ESLASHT datasheet(8/21 Pages) DALLAS

8 / 21 page

DS1305

8 of 21

STATUS REGISTER (READ 10H)

BIT7

BIT6

BIT5

BIT4

BIT3

BIT2

BIT1

BIT0

IRQF1

IRQF0

IRQF0 (Interrupt 0 Request Flag) – A logic 1 in the interrupt request flag bit indicates that the current

time has matched the Alarm 0 registers. If the AIE0 bit is also a logic 1, the INT0 pin goes low. IRQF0 is

cleared when the address pointer goes to any of the Alarm 0 registers during a read or write.

IRQF1 (Interrupt 1 Request Flag) – A logic 1 in the interrupt request flag bit indicates that the current

time has matched the Alarm 1 registers. This flag can be used to generate an interrupt on either INT0 or

INT1

depending on the status of the INTCN bit in the control register. If the INTCN bit is set to a logic 1

and IRQF1 is at a logic 1 (and AIE1 bit is also a logic 1), the INT1 pin goes low. If the INTCN bit is set

to a logic 0 and IRQF1 is at a logic 1 (and AIE1 bit is also a logic 1), the INT0 pin goes low. IRQF1 is

cleared when the address pointer goes to any of the Alarm 1 registers during a read or write.

TRICKLE CHARGE REGISTER (READ 11H, WRITE 91H)

This register controls the trickle charge characteristics of the DS1305. The simplified schematic of Figure

3 shows the basic components of the trickle charger. The trickle-charge select (TCS) bits (bits 4–7)

control the selection of the trickle charger. To prevent accidental enabling, only a pattern of 1010 enables

the trickle charger. All other patterns disable the trickle charger. On the initial application of power, the

DS1305 powers up with the trickle charger disabled. The diode select (DS) bits (bits 2–3) select whether

one diode or two diodes are connected between VCC1 and VCC2. The resistor select (RS) bits select the

resistor that is connected between VCC1 and VCC2. The resistor and diodes are selected by the RS and DS

bits, as shown in Table 2.

Figure 3. PROGRAMMABLE TRICKLE CHARGER

DS1305E/T Datasheet(PDF) 8 Page - Dallas Semiconductor