This cost-effective Disposable Heel Grounder provides static protection and

is excellent for one-time use applications, including one-time use by visitors

in electronics manufacturing locations, for field service and remote electronic

equipment installations.

This Heel Grounder provides a conductive path from the person to the walking

surface. Adhesive holds the grounder to the sole of the shoe. No metal clips

or glue are attached to the upper part of the shoe, avoiding wear. Yellow color

makes heel grounder verification simple. Grounders are packaged 100 per

bag.

Installation:

1. Insert the non-adhesive end of the heel grounder inside the shoe so that

the black dot is in the center of the heel area.

2. Wrap the heel grounder around the back (or side) of shoe so that the

adhesive can be adhered to the bottom of the heel.

3. Remove perforated section by lifting the paper backing from the middle

as shown.

4. Press adhesive part of the foot grounder to the heel of the shoe. Do not

allow adhesive to come in contact with any part of the shoe except for

the heel. The adhesive may leave a residue.

5. Step in to shoe. Disposable heel grounder is to be installed on both

shoes and used with ESD flooring.

6. Test each worn foot grounder with a Personal Grounding Tester

DRAWING

NUMBER

5402

DATE

August

2015

© 2015 DESCO INDUSTRIES INC.

Employee Owned

5402 DISPOSABLE HEEL GROUNDER

926 JR Industrial Drive, Sanford, NC 27332

WEB SITE: StaticControl.com

PHONE (919) 718-0000

Specifications and procedures subject to change without notice.

Specifications

Typical Value

Size

1/2" W x 12" L

Resistance to Ground (Rtg)

≥ 5 x 104 < 8 x 105 ohms

Made in the

United Kingdom

12"

Yellow Polyester Material

Black Conductive Strip

1/2"

Bottom Heel of

Shoe

Remove perforated section here

and begin peeling towards the left

Item

Description

Length

Package

5402

Disposable Heel Grounder

12"

100 per bag

Unless otherwise noted, tolerance ± 10%