9 / 15 page

Radiometrix Ltd, SpacePort Modem
page 9
RADAR
Starts the radar test.
Used as a range or confidence test between SPM modules within the
same site.
parameter
Unit number between 0 and 15.
Note: To configure the SPM the HyperTerminal should be set with the following settings.
Hardware flow control should be disabled. Default baud rate of the SPM is 9600bps. However if
the default baud rate of the SPM is changed then the baud rate of the HyperTerminal should be
matched or DEFAULT jumper should be connected to force the SPM baud rate to 9600bps.
Figure 4: SPM2 configuration using HyperTerminal