Because Whirlpool Corporation includes a continuous commitment to improve our

products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation

Instructions packed with product. Specifications subject to change without notice.

Ref. W10403811C

05/20/2016

30" (76.2 cm) Freestanding Electric Range

PRODUCT MODEL NUMBERS

WFC110

WFC120

WFC130

WFC150

WFC310

WFC340

WFE320

WFE330

WFE510

WFE515

WFE520

WFE524

WFE525

WFE530

WFE540

WFE710

WFE714

WFE720

WFE745

WFE770

WFE905

WFI910

Electrical: To properly install your range, you must determine the type

of electrical connection you will be using and follow the instructions

provided for it here.

■

Range must be connected to the proper electrical voltage and

frequency as specified on the model/serial number rating plate. The

model/serial number rating plate is located on the left-side frame

behind the storage drawer panel or behind the top right side of the

oven door. Refer to the figures in the “Product Dimensions” section of

the “Location Requirements” section.

■

This range is manufactured with the neutral terminal connected to

the cabinet. Use a 3-wire, UL Listed. 40- or 50-amp power supply

cord (pigtail) (see following Range Rating chart). If local codes do not

permit ground through the neutral, use a 4-wire power supply cord

rated at 250 volts, 40 or 50 amps and investigated for use with ranges.

Range Rating*

Specified Rating

of Power Supply

Cord Kit and

Circuit Protection

120/240 Volts

120/208 Volts

Amps

8.8 – 16.5 KW

7.8 – 12.5 KW

40 or 50 **

16.6 – 22.5 KW

12.6 – 18.5 KW

50

* The NEC calculated load is less than the total connected load listed on

the model/serial rating plate.

** If connecting to a 50-amp circuit, use a 50-amp rated cord with a kit.

For 50-amp rated cord kits, use kits that specify use with a nominal

13/8" (34.9 mm) diameter connection opening.

■

A circuit breaker is recommended.

PRODUCT DIMENSIONS

A

B

C

D

E

F

A. 273/4" (70.5 cm) max. depth with handle

B. 467/8" (119.1 cm) overall height (max.) with leveling legs

screwed all the way in*

C. 36" (91.4 cm) cooktop height (max.) with leveling legs screwed

all the way in*

D. 297/8" (75.9 cm) width

E. 255/16" (64.3 cm) depth – back of range to front of cooktop**

F. Model/serial rating plate (located on the left-side frame behind

storage drawer or right side of frame behind the oven door)

IMPORTANT: Range must be level after installation. Follow the

instructions in the “Level Range” section. Using the cooktop as a

reference for leveling the range is not recommended.

* Range can be raised approximately 1" (2.5 cm) by adjusting the

leveling legs.

** Front of door and drawer may extend further forward depending on

styling.

Cabinet opening dimensions shown are for 25" (64.0 cm) countertop

depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop

height.

IMPORTANT: If installing a range hood or microwave hood combination

above the range, following the range hood or microwave hoods

combination instructions for dimensional clearances above the cooktop

surface.

A freestanding range may be installed next to combustible walls with

zero clearance.

*

NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet

is covered by not less than 1/4" (0.64 cm) flame retardant millboard

covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)

stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

CABINET OPENING DIMENSIONS

A

B

D

F

E

C

A. 13" (33.0 cm) max.

upper cabinet depth

B. 30" (76.2 cm) min.

opening width

C. For minimum clearance

to top of cooktop, see

NOTE*

D. 301/8" (76.5 cm) min

opening width

E. Outlet – 8" (20.3 cm)

to 22" (55.9 cm)

from either cabinet,

51/2" (14.0 cm) max. to

floor

F. Cabinet door or hinges

should not extend into

the cutout