4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

Before switching the product on, make sure that the voltage of your electricity supply

is the same as that indicated on the rating plate. This product is designed to operate

on 230VAC 50Hz. Connecting it to any other power source may cause damage.

This product can be used with either a standard plug or a fused connection unit

(FCU). If it is necessary to change the fuse in the plug or FCU, the fuse cover must be

refitted. If the fuse cover becomes lost or damaged, the plug or FCU must not be

used until a suitable replacement is obtained.

If the plug has to be changed because it is not suitable for your socket, or due to

damage, a replacement should be fitted, following the wiring instructions shown on

page 5. The old plug must be disposed of safely, as insertion into a mains socket

could cause an electrical hazard.

If the colours of the wires in the power cable of this product do not correspond with

the markings on the terminals of your plug or spur, proceed as follows.

• The Blue wire must be connected to the terminal which is marked N or

coloured Black.

• The Brown wire must be connected to the terminal which is marked L or

coloured Red.

• The Yellow and Green wire must be connected to the terminal which is

marked E,

or coloured Green.

WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE

MAINS SUPPLY.

Fused Connection Unit (FCU) must be

Always fit a

Neutral

(Blue)

Earth

(Green and Yellow)

Live

(Brown)

Ensure that the outer sheath of the cable is firmly held by the clamp

13 Amp fuse.

BS1363/4 approved.