8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

BATTERY CHARGING

The battery will have been shipped in a low charge state and will require

charging before use.

1. Press the battery release clip on

the front of the battery pack and

slide the battery pack from the

impact wrench.

2. Plug the charger into a 230V

power supply and switch ON.

• The green POWER ON light will

illuminate to show the unit is

connected to the mains supply.

3. Insert the battery pack into the

battery charger, noting that it will

only fit one way.

• The red light will flash to indicate

the battery is starting to charge.

• When charging is complete

(typically after about 1.5 hours),

the green light will come on and

the red light will go off. The

battery pack can be

considered charged and be

removed. Charging time will be

dependant upon the initial state

of the battery.

• When charging a new battery pack, it may initially not accept full

charge. This is common & does not indicate a fault. It can be

recharged fully after it has been discharged a couple of times.

• If charging does not take place, ensure all connections are clean.

4. After charging, switch off and unplug the charger from the power supply.

5. Remove the battery pack from the charger and slide it back onto the

impact wrench until it clips into place.

The battery pack should slide in easily. If it is not to be fitted immediately,

ensure that the metal contacts are protected to avoid the possibility of a short

circuit which would cause battery damage. For maximum battery life, we

recommend that you maintain the battery in a fully charged state.