2. Operating the Gun

The gun is operated by first placing it directly over

the point to be stapled and holding down firmly with

the palm of one hand, on the pressure screw (C) whilst

pressing down firmly and progressively on the handle

(B), until the gun ‘fires’ and the staple or nail is inserted.

To assist in positioning the staple correctly, the front

face of the gun has a notch at its base, to indicate the

place at which stapling will occur. The notch should

be centered over the point to be stapled.

If you are using nails, then the edge of the notch is

similarly placed over the point to be nailed, (which

side, depends upon which carriage rail the nails are

located).

The pressure screw (C) may be adjusted so that it will

apply the appropriate force to the staple or nail,

depending upon the material being stapled.

Note: The softer the material, the less force will be

required to drive in the staple or nail. Excessive

force may damage the material being stapled.

It is advised therefore, that where necessary, you

should slacken off the pressure screw and test its

action, progressively increasing the pressure by

turning the screw until you determine the pressure

required to correctly staple the material without it

being damaged.

If you are stapling fabric, take care not to use too

great a pressure as this may cause the staple to go

right through, tearing the fabric.

NOTE: A hole is provided in the body, shown at

‘D’, through which the staples may be viewed. By

keeping an eye on this,it is possible to determine

when a reload is required.

MAINTENANCE

In the event the gun jams, and/or staples become

enmeshed within the gun, proceed as follows:

(a)

Remove the pressure rod and spring assembly

(G).

(b)

The carriage (E) is held in place by two lugs on

its front end, which locate into two slots in the front

edge of the gun. Holding the gun firmly, pull back the

carriage against spring pressure, using the finger grips

(F), on its sides. This will dislocate the lugs from their

slots. Apply a downwards pressure on the carriage

and release it, allowing it to swing on its hinge as

illustrated.

NOTE: If difficulty is encountered in pulling back

on the lugs, it may be necessary to use a tool (e.g.

plyers) to grasp the open end of the carriage and

pull back in order to dislocate the lugs.

Any damaged material may now be carefully

removed using a pair of pliers or similar.

When replacing the carriage, ensure it is completely

forward and the lugs are fully engaged in their

slots. Failure to comply with this rule may cause

the gun to jam.

IMPORTANT: Always remove the Pressure Rod

and Spring Assembly BEFORE dislocating the

carriage. Failure to follow this rule could

result in personal injury.

When you have finished using the gun, always remove

any unused staples or nails, and relieve the pressure

on the spring by unscrewing the pressure screw (C).

Secure the handle with the safety catch (A).

Hemnall Street, Epping, Essex CM16 4LG

ACCESSORIES

A range of replacement staples and nails are

available from your CLARKE dealer, including the

following:

Item

Part No.

Square Staples 6mm

1800240

Square Staples 8mm

1800245

Square Staples 10mm

1800250

Square Staples 12mm

1800255

Square Staples 14mm

1800260

Round Staples 12mm

1800230

SPARE PARTS

Item Description

Part No.

G

Rod Assembly

KL18004

C

Adjuster Screw

KL18002

For sales and service, contact your Clarke

dealer. For details of your nearest dealer

contact:

CLARKE International on 01992 565300

or e-mail:

Sales@clarkeinternational.com