PLS180 datasheet(21/40 Pages) CLARKE

21 / 40 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

7. Apply the detergent to a dry

surface, starting at lower

portions of the area to be

cleaned and work upwards using

long even overlapping strokes.

8. Allow the detergent to soak in

for 3-5 minutes before washing

and rinsing. Reapply as needed

to prevent surface from drying.

DO NOT allow detergent to dry

on to prevent streaking.

NOTE: You must flush the detergent syphoning system after each use by placing the

filter and detergent hose in a bucket of clean water, then run the pressure

washer at low pressure for 1-2 minutes.

RINSING

1. Disconnect the detergent hose from the inlet and remove from the detergent tank.

Replace the tank cap.

2. Remove the black nozzle tip from the spray gun.

3. Select and install the desired high pressure nozzle tip.

4. Decrease the spray pressure by

turning the pressure control

knob counterclockwise, or

clockwise for increased pressure.

5. Use lower pressure to wash

items such as a car or boat. Use

the higher pressure to strip paint

and degrease driveways.

6. Apply a high pressure spray to a

small area and then check the

surface for any damage. If no

damage is found, you can

assume it is OK to continue

rinsing.

7. Start at the top of the area to be

rinsed, working down with the same overlapping strokes as you used for cleaning.

PLS180 Datasheet(PDF) 21 Page - Clarke International