4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an

approved 13 amp BS 1363 plug, or a suitably fused isolator switch.

If the plug has to be changed because it is not suitable for your socket, or because of

damage, it must be removed and a replacement fitted, following the wiring

instructions shown below. The old plug must be discarded safely, as insertion into a

power socket could cause an electrical hazard

.

If the colours of the wires in the power cable do not agree with the markings on the

plug.

• The BLUE wire must be

connected to the terminal

marked N.

• The BROWN wire must be

connected to the terminal

marked L.

• The YELLOW AND GREEN

wire must be connected to

the terminal marked E or

.

AN APPROVED RESIDUAL CURRENT DEVICE (RCD) WHICH HAS A

TRIPPING CURRENT OF LESS THAN 30MA MUST BE USED.

If you are not sure, consult a qualified electrician. DO NOT try to do any repairs.

WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE

MAINS SUPPLY.

WARNING: THE WIRES IN THE POWER CABLE OF THIS

PRODUCT ARE COLOURED IN ACCORDANCE WITH THE

FOLLOWING CODE:

BLUE = NEUTRAL

BROWN = LIVE

YELLOW AND GREEN =

EARTH

Plug must be BS1363/A approved.

Always fit

Ensure that the outer sheath of

Neutral

(Blue)

Live

(Brown)

Earth

(Green and

a 13 Amp

the cable is firmly held by the clamp

fuse.

Yellow)