2

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INTRODUCTION

Thank you for purchasing this CLARKE product.

Please follow the instructions given. In doing so you will ensure the safety of

yourself and that of others around you and you can look forward to the

product giving you long and satisfactory service.

.Always read the safety warnings before use.

Tested in accordance with BS EN 60974-13:2021.

WARNING: ELECTRIC SHOCK CAN KILL. DO NOT TOUCH LIVE ELECTRICAL PARTS

WITH BARE HANDS AND DO NOT USE WET OR DAMP GLOVES OR CLOTHING. USE

THIS CLAMP ONLY FOR ELECTRICAL WELDS AND FOR RETURN CURRENT OF THE

WELDING CIRCUIT.

For electrical conductivity make sure that the welding cable is properly

connected to the clamp. The end of the cable must be properly sheathed

and secured by tightening the special pins or the bolt of the cable clamp

plate.

Use the cable section indicated above.

Make sure that the clamp is properly connected to the workpiece to be

welded, cleaning the contact area adequately.

Welding gloves must be worn when using this clamp. DO NOT use at a higher

amperage than the approved amperage rating.

DO NOT use this clamp for purposes other than those specified. If it is

damaged, the clamp must be replaced.

Cleaning and repair of the welding machine MUST BE CARRIED OUT with the

machine SWITCHED OFF and disconnected from the electrical supply.

Model No

EC200

EC300

EC500

Part No

8135435

8135440

81354345

Amperage at 30% Duty

500A

Amperage at 40% Duty

300A

Amperage at 60% Duty

200A

Cable Section

25-35mm2

25-50mm2

35-70mm2