4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ASSEMBLY

Refer to parts diagram - page 7.

CONNECTION OF THE PRESSURE REDUCER

1. Check to ensure the pressure reducer is correct both for the type of gas

and the pressure in the cylinder to be used.

2. Turn the pressure adjuster (6) fully anticlockwise, to ensure the pressure

reducer valve is closed.

3. Before screwing on the pressure reducer, briefly open the cylinder valve (1)

then close it, in order to remove any impurity, dust etc. from the outlet.

4. Replace the gasket (2) if damaged or lost (CO2 ONLY).

NOTE: During this operation DO NOT place your hands over the cylinder

outlet.

5. Screw the inlet connection (3) tightly to the cylinder valve, using a suitable

spanner.

HOSE CONNECTION

1. Attach the hose to the hose connection of the outlet connection (8) and

tighten with suitable clamps (not provided).

INSTRUCTIONS FOR USE

OPENING THE PRESSURE VALVE

1. Check to ensure the reducer is completely closed (turn the pressure

adjusting knob (6) fully anticlockwise).

2. Slowly open the cylinder valve (1). The high pressure gauge (4) will indicate

the cylinder pressure.

WARNING: OPENING THE CYLINDER VALVE TOO QUICKLY MAY CAUSE THE GAUGE

TO MALFUNCTION.

3. Turn the pressure adjusting knob (6) very slowly clockwise. The low pressure

gauge (5), if fitted, will indicate the outlet pressure.