16

©2021 Renesas Electronics Corporation

R31DS0007EU0100 April 8, 2021

XT Datasheet

Package Outline Drawings

The package outline drawings are located at the end of this document and are accessible from the Renesas website. The package

information is the most current data available and is subject to change without revision of this document.

Marking Diagram

Figure 12. Marking Configuration for the 3.2 × 2.5 mm (LNG8) Package (example based on

XTL312625.000000I)

Revision History

Revision Date

Description of Change

April 8, 2021

Initial release.

▪ Line 1 denotes the truncated part number as follows:

• “D” = a combination of the 3rd digit (output type, e.g. “L”) and the 5th digit (voltage supply, e.g. “3”), in

accordance with the mapping key as follows:

▪ C1 = A, C2 = B, C3 = C, L1 = D, L2 = E, L3 = F, N1 = G, N2 = H, N3 = J, P1 = K, P2 = L, P3 = M

• “xxxxxx” = the first three digits to the left of the decimal point and the last three digits to the left of the decimal

point as shown in the above example. This number will vary depending upon the frequency value selected in

the orderable part number. (e.g. 625000).

▪ Line 2 indicates the following:

• “YWW” denotes the last digit of the year and week when the part was assembled.

• “**” denotes the sequential lot number.

• “$” denotes the mark location.

Dxxxxxx

YWW**$