ST20-JPI

5/10

®

2.2

Hardware Installation - B300

The ST20-JPI can also be attached to the Ethernet via a B300. To install the hardware connecting

to a B300, the following steps should be followed:

•

Connect the B300 to the ST20-JPI using a Differential OS-Link cable supplied with the

B300.

•

Plug the target development system into the 20-way IDC connector using a 20 way IDC

cable.

•

Plug power supply cable into PSU socket of the interface.

•

Plug the power supply into the mains socket.

•

Switch on the B300.

•

Switch on the power supply to the ST20-JPI. The LEDs on the interface should illuminate

once the software is running. For a description of the meaning of the LEDs, see the ST20

toolset documentation.

•

Switch on the Target power supply.

2.3

Software Installation

For installation of the DLL and VxD drivers, please refer to the ST20 Toolset software installation

documentation.