M48Z02 datasheet(11/20 Pages) STMICROELECTRONICS

11 / 20 page

M48Z02, M48Z12

Operation modes

11/20

Figure 7.

Checking the BOK flag status

2.4

VCC noise and negative going transients

ICC transients, including those produced by output switching, can produce voltage

fluctuations, resulting in spikes on the VCC bus. These transients can be reduced if

capacitors are used to store energy which stabilizes the VCC bus. The energy stored in the

bypass capacitors will be released as low going spikes are generated or energy will be

absorbed when overshoots occur. A ceramic bypass capacitor value of 0.1µF (as shown in

Figure 8 on page 12) is recommended in order to provide the needed filtering.

In addition to transients that are caused by normal SRAM operation, power cycling can

generate negative voltage spikes on VCC that drive it to values below VSS by as much as

one volt. These negative spikes can cause data corruption in the SRAM while in battery

backup mode. To protect from these voltage spikes, STMicroelectronics recommends

connecting a schottky diode from VCC to VSS (cathode connected to VCC, anode to VSS).

Schottky diode 1N5817 is recommended for through hole and MBRS120T3 is

recommended for surface mount.

READ DATA

AT ANY ADDRESS

AI00607

IS DATA

COMPLEMENT

OF FIRST

READ?

(BATTERY OK)

POWER-UP

YES

WRITE DATA

COMPLEMENT BACK

TO SAME ADDRESS

READ DATA

AT SAME

ADDRESS AGAIN

NOTIFY SYSTEM

OF LOW BATTERY

(DATA MAY BE

CORRUPTED)

WRITE ORIGINAL

DATA BACK TO

SAME ADDRESS

(BATTERY LOW)

CONTINUE

M48Z02 Datasheet(PDF) 11 Page - STMicroelectronics

M48Z02 Datasheet(HTML) 11 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Datasheet Download

Link URL