STW5094ADTSLASHLF datasheet(8/52 Pages) STMICROELECTRONICS

8 / 52 page

7/51

STw5094A

DOT

Transmit Data output: Data is shifted out on this pin during the assigned

transmit time slots. Elsewhere DX output is in the high impedance state.

In delayed and non-delayed normal frame sync modes, voice data byte

is shifted out from tristate output DX at the MCLK frequency on the

rising edge of MCLK, while in non-delayed reverse frame sync mode

voice data is shifted out on the falling edge of MCLK.

Receive data input: Data is shifted in during the assigned Received time

slots In delayed and non-delayed normal frame sync modes voice data

byte is shifted in at the MCLK frequency on the falling edges of MCLK,

while in non-delayed reverse frame sync mode voice data byte is shifted

in on the rising edge of MCLK.

Frame Sync input for Voice Mode: This signal is a 8

⁄ 16kHz clock

which defines the start of the transmit and receive frames. Any of three

formats may be used for this signal: non delayed normal mode, delayed

mode, and non delayed reverse mode.

MCLK

Master Clock Input for Voice Mode. Can also be used as Master Clock in

Tone Only and FM Modes. The allowed clock frequencies are 512 kHz,

1.536 MHz, 2.048 MHz or 2.56 MHz. MCLK is the Voice Data Clock.

AUXCLK

Auxiliary Clock Input. Can be used as Master Clock in Tone Only and

FM Modes. Allowed clock frequencies are 512kHz, 1.536MHz,

2.048MHz or 2.56MHz.

VCMHP

VCM Driver Output. Can be used as common mode node for HPL and

HPR outputs.

CAP2

A capacitor must be connected between this node and Ground.

VCCA

Power supply input for the analog section. VCC and VCCA can be

directly connected together for low cost applications.

GNDA

Analog Ground: All analog signals are referenced to this pin. GND and

GNDA can be connected together for low cost applications.

VCCP

Power supply input for the output drivers.

GNDP

Power ground. Output drivers are referenced to this pin. GNDP and

GNDA must be connected together.

GNDCM

Analog Ground connection. GNDCM can be connected to GNDA.

VCC

Power supply input for the digital section.

GND

Ground for the digital section

VCCIO

Power supply Input for the Digital I

⁄ O pins.

Pin N°

Name

Type

Description

STW5094ADT/LF Datasheet(PDF) 8 Page - STMicroelectronics

STW5094ADT/LF Datasheet(HTML) 8 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Datasheet Download

Link URL