M52390FP

Rev.1.0, Sep.22.2003, page 19 of 22

(6) The relationship between BFP and HHK

The pulse width of BFP and HHK can be set as shown in Fig. 4, using the [3] (HHK) external CR.

(7) Input pin drive

Input pins [9], [16], [17], and [18] use clamp input, so they should always be driven with a low impedance.

(8) Input/output relationship between SYNC and burst during the V cycle

1) V DL is used to adjust the timing of the RGB encoder signal and the VIDEO IN signal.

using the amount of delay shown below as a guide.

V DL = Y DL (item 4) + 10 (ns)