3

0344H–EPROM–12/07

AT27BV010

3.

System Considerations

Switching between active and standby conditions via the Chip Enable pin may produce transient

voltage excursions. Unless accommodated by the system design, these transients may exceed

datasheet limits, resulting in device non-conformance. At a minimum, a 0.1 µF high frequency,

low inherent inductance, ceramic capacitor should be utilized for each device. This capacitor

should be connected between the V

device as possible. Additionally, to stabilize the supply voltage level on printed circuit boards

with large EPROM arrays, a 4.7 µF bulk electrolytic capacitor should be utilized, again con-

nected between the V

possible to the point where the power supply is connected to the array.

4.

Block Diagram

Note:

1. Minimum voltage is -0.6V DC which may undershoot to -2.0V for pulses of less than 20 ns. Maximum output pin voltage is

overshoot to +7.0V for pulses of less than 20 ns.

5.

Absolute Maximum Ratings*

Temperature Under Bias.................................. -40°C to +85°C

*NOTICE:

Stresses beyond those listed under “Absolute

Maximum Ratings” may cause permanent dam-

age to the device. This is a stress rating only and

functional operation of the device at these or any

other conditions beyond those indicated in the

operational sections of this specification is not

implied. Exposure to absolute maximum rating

conditions for extended periods may affect

device reliability

Storage Temperature ..................................... -65°C to +125°C

Voltage on Any Pin with

Respect to Ground .........................................-2.0V to +7.0V(1)

Voltage on A9 with

Respect to Ground ......................................-2.0V to +14.0V(1)

Respect to Ground .......................................-2.0V to +14.0V(1)