3

RH1083M

PARAMETER

CONDITIONS

MIN

MAX

MIN

MAX

MIN

MAX

MIN

MAX

MIN

MAX UNITS

Reference Voltage (Note 3)

1.234

1.258

1.232

1.257

1.227

1.253 1.223

1.247

1.216

1.241

V

10mA

1.210

1.275

1.219

1.275

1.215

1.275 1.210

1.275

1.203

1.275

V

1.5V

Line Regulation (Notes 1, 2)

1.5V

0.2

0.21

0.23

0.25

0.3

%

15V

0.5

0.5

0.5

0.5

0.5

%

Load Regulation (Notes 1, 2, 3)

0.3

0.3

0.3

0.35

0.4

%

10mA

Dropout Voltage (Note 4)

1.5

1.55

1.65

1.8

2.0

V

Current Limit

8

8

7.95

7.85

7.75

V

0.4

0.4

0.4

0.4

0.4

V

Minimum Load Current

10

10

10

10

10

mA

Adjust Pin Current

120

120

120

120

120

μA

Adjust Pin Current Change

10mA

55

5

5

5

μA

(Note 5)

1.5V

10KRAD(Si)

20KRAD(Si)

50KRAD(Si)

100KRAD(Si)

200KRAD(Si)

TABLE 2: ELECTRICAL TEST REQUIRE E TS

MIL-STD-883 TEST REQUIREMENTS

SUBGROUP

Final Electrical Test Requirements (Method 5004)

1*,2,3

Group A Test Requirements (Method 5005)

1,2,3

Group C and D End-Point Electrical Parameters

1,2,3

(Method 5005)

* PDA Applies to subgroup 1. See PDA Test Notes.

Note 1: See thermal regulation specifications for changes in output voltage

due to heating effects. Line and load regulation are measured at a constant

junction temperature by low duty cycle pulse testing.

Note 2: Line and load regulation are guaranteed up to the maximum power

dissipation of 60W for RH1083M. Power dissipation is determined by the

input-to-output differential voltage and the output current. Guaranteed

maximum power dissipation will not be available over the full input-to-

output voltage range.

limit as a function of input-to-output voltage. Note that the 60W power

dissipation for the RH1083M is achievable over a limited range of input-to-

output voltage. For compliance with 883 revision C current density

specifications, the RH1083M is rated for 5A.

Note 4: Dropout voltage is specified over the full output current range of

the device. Test points and limits are shown on the Dropout Voltage curve

in the standard data sheet.

Note 5: Guaranteed by design, characterization, or correlation to other

tested parameters.

PDA Test Notes

The PDA is specified as 5% based on failures from group A, subgroup 1,

tests after cooldown as the final electrical test in accordance with method

5004 of MIL-STD-883 Class B. The verified failures of group A, subgroup

1, after burn-in divided by the total number of devices submitted for burn-

in in that lot shall be used to determine the percent for the lot.

Linear Technology Corporation reserves the right to test to tighter limits

than those given.

Information furnished by Linear Technology Corporation is believed to be accurate and reliable.

However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-

tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.