GAMEWELL-FCI

12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118

Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.

©2007 Honeywell International Inc. All rights reserved.

www.gamewell-fci.com

CS-2047 Rev. A page 1 of 2

SCE-95

Signal Control Element

An ISO 9000-2000 Company

APPROVED

FM

SIGNALING

S521

7300-1288:147

MEA

Approved

Description

The Gamewell-FCI Signal Control Elements (SCE-95) is

the interface between the Fire Alarm Control Panel's

(FACPs) analog circuits and building functions. The SCE-

95 connects to the panel via the SLC circuit. The SCE-95

provides a means to remotely locate a fully supervised cir-

cuit for the operation of signaling appliances such as

horns, strobes, and horn/strobes. The SCE-95 works with

all 600 Series analog addressable FACPs. For annuncia-

tion and feedback at the panel, Gamewell-FCI offers a Sig-

nal Control Display (SCD). The SCD is only available with

the IF632 and IF650 FACPs.

The SCE-95 is capable of switching 24 VDC. When used

as a remote signaling circuit the SCE-95 provides all the

necessary supervision of the circuit and trouble reporting

via the analog circuit.

The Signal Control Element (SCE-95) is designed for sur-

face or flush mounting and has an integral LED which

annunciates upon device activation.

Operation

The signal control element connects to the SLC of the Fire

Alarm Control Panel (FACP) via two-wires. In its standby

mode, the SCE-95 monitors its internal circuitry for status

of the device itself and supervises the external control cir-

cuit for faults. In the event that a fault is detected, the SCE-

95 will report a trouble to the FACP.

When an event is reported to the Fire Alarm Control Panel

(FACP) that requires the activation of the SCE-95, the con-

trol panel communicates via the analog circuit to the SCE-

95 and the signaling circuit is actuated. The integral LED is

also lit for annunciation at the device.

Programming

The SCE-95 is programed by setting a single DIP switch

easily accessible on the printed circuit board. The SCE-

95’s DIP switch is used to set the address of the device.

Features

•

Compatible with the Gamewell-FCI 600 Series analog

addressable FACPs.

•

Supervises and operates notification appliance circuit.

•

Supervises DC power-in.

•

LED annunciates activation.

•

Fully supervised.

•

Surface or flush mounting.

•

Field programmable.

•

Style four, six, or seven wiring.

•

Screw terminals for field wiring connections.

•

2.0 A output..

SCE-95