2

Step 7

Lubricate the distributor shaft and the top and bottom

of the thrust washer. A light coating of moly lube/

grease or similar lubricant is acceptable. Install the

reluctor sleeve and advance plate on the distributor

shaft. Install the felt pad into the top hole of the

reluctor sleeve.

Step 8

Install the advance weights and bushings. Install the

two E-clips. Install the advance springs.

Step 9

See Figure 3.

Install the module assembly into the housing. Make

sure that the cut-out in the plate is directly below the

hole in the housing where the wires will exit.

Step 10

Tighten the two nuts that hold the cap clips/brackets

in place. This also secures the module plate.

Marine Distributors Only

Replace the cap clips using the new aluminum pins

provided.

Step 11

Install the wire grommet. Lubricate the wires with light

oil. Run the wires through the grommet and out of the

distributor housing.

Step 12

Put the three wires into the female connector:

GREEN WIRE in hole #1

BROWN WIRE in hole #2

RED WIRE in hole #3

Plug the female connector into the distributor wire

harness. See Figure 3.

Step 13

Connect the three wires of the wire harness to the

correct locations as indicated in Figures 5 and 6.

Step 14

Set the pickup gap (see Figure 4).

Step 15

If the distributor was removed from the engine,

reinstall. Install the cap, rotor, and plug wires. Static

time the engine. Start the engine and recheck the

timing.

LEFT HAND ROTATION

RIGHT HAND ROTATION

FIGURE 1

Insulators

Point Plate

Cap Clip

Nuts

Condensor

FIGURE 2

Advance Spring

E-Clip

Advance Plate

YH ADVANCE

Sleeve