MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP

550 MALLORY WAY, CARSON CITY, NEVADA 89701

(775) 882-6600

FAX (775) 887-4326

www.mrgasket.com

FORM #1479

(REV. A) 9/99

Made in U.S.A.

Printed in U.S.A.

Step 3

Remove the cover from the Mallory distributor by removing the two screws.

the "X" on the shutter wheel. Install the Mallory distributor in the engine. Be

sure that the distributor wires exit on the side closest to the cylinders.

Step 4

Install a distributor clamp. Do not tighten the clamp at this time.

Step 5

Rotate the distributor until the "X" on the shutter wheel lines up with the arrow

Tighten the distributor clamp.

Step 6

Connect the wires (See Figures C and D).

Step 7

Replace the Mallory cover and install the two screws to hold it in place.

Start the engine and check the timing with a timing light. NOTE: When

checking the timing, engine RPM must be above 2000 for accurate timing

results.

FIGURE B

SINGLE PLUG HEADS

GREEN

RED

2 TO 4 OHM

BROWN

GROUND

12 VOLTS FROM IGNITION SWITCH

FIGURE C

DUAL PLUG HEADS

GREEN

JUMPER

12 VOLTS FROM IGNITION SWITCH

RED

BROWN

GROUND

1 TO 2 OHM

1 TO 2 OHM

FIGURE D

NOTE: Arrow and X in photo have been enlarged for clarity.