SC23R01

HANGZHOU SILAN MICROELECTRONICS CO.,LTD

REV:1.1

2006.10.31

Http: www.silan.com.cn

Page 2 of 7

PIN CONFIGURATION

2

1

RF2

RF1

XOA2

FUNCTION DESCRIPTION

1. RF interface and read/write device

1.1 Request

REQ STD/ALL

The communication protocol of SC23R01 is complied with the ISO14443A. When the card is positioned in the

proximity of the read/write device (RWD), the RWD sends the REQ STD/ALL command to confirm whether the

card is SC23R01.

1.2 Anti-collision loop

When there are several cards in the operating rang of the RWD, the anticollision algorithm selects one card for

further transaction. The unselected card return to the standby mode and wait for a new request command. In this

course, it will return the serial number of the card.

1.3 Select card

Select the serial number of the selected card, the card returns the answer to select code (=08H).

1.4 3 Pass authentication

After selecting the card, the RWD specifies the memory location which needs access, and uses the

corresponding key for 3 pass authentication. After authenticating successfully, all memory operations are

encrypted. (for selecting another sector, the key should be authenticated again) .

1.5 Memory operations

After authentication, the following operation may be performed:

Read: read block.

Write: write block.

Decrement: decrease the content of a block and store the result in a data register.

Increment: increase the content of a block and store the result in a data register.

Transfer: write the content of data register to a value block.

Restore: read the content of the value block to the data register.

Halt: set the card in the halt mode.

The operation flow chart: