MPR031 datasheet(15/32 Pages) FREESCALE

15 / 32 page

MPR03X

Sensors

Freescale Semiconductor

Interrupts

6.1

Introduction

The MPR03X has one interrupt output that is triggered on any touch related event. The interrupts trigger on both the up or down

motion of a finger as defined by a set of configurable thresholds.

6.2

Triggering an Interrupt

An interrupt is asserted any time data changes in the Touch Status Register (Section 5.2). This means that if an electrode touch

or release occurs, an interrupt will alert the application of the change.

6.3

Interrupt Handling

The MPR03X has one interrupt output that is asserted on any touch related event. The interrupts trigger on both the up or down

motion of a finger as defined by a set of configurable thresholds as described in Section 9. To service an interrupt, the application

must read the Touch Status Register (Section 5.2) and determine the current condition of the system. As soon as an I2C read

takes place the MPR03X will release the interrupt.

6.4

IRQ Pin

The IRQ pin is an open-drain latching interrupt output which requires an external pull-up resistor. The pin will latch down based

on the conditions in Section 6.2. The pin will de-assert when an I2C transaction reads from the MPR03X.

MPR031 Datasheet(PDF) 15 Page - Freescale Semiconductor, Inc