ATmega128 datasheet(117/386 Pages) ATMEL

117 / 386 page

117

2467S–AVR–07/09

ATmega128

The following code examples show how to do an atomic write of the TCNTn Register contents.

Writing any of the OCRnA/B/C or ICRn Registers can be done by using the same principle.

Note:

1. See “About Code Examples” on page 9.

The assembly code example requires that the r17:r16 register pair contains the value to be

written to TCNTn.

Reusing the

Temporary High Byte

If writing to more than one 16-bit register where the high byte is the same for all registers written,

then the high byte only needs to be written once. However, note that the same rule of atomic

operation described previously also applies in this case.

Assembly Code Example

(1)

TIM16_WriteTCNTn:

; Save global interrupt flag

r18,SREG

; Disable interrupts

cli

; Set TCNTn to r17:r16

out

TCNTnH,r17

out

TCNTnL,r16

; Restore global interrupt flag

out

SREG,r18

ret

C Code Example

(1)

void

TIM16_WriteTCNTn( unsigned int i )

{

unsigned char

sreg;

unsigned int

/* Save global interrupt flag */

sreg = SREG;

/* Disable interrupts */

__disable_interrupt();

/* Set TCNTn to i */

TCNTn = i;

/* Restore global interrupt flag */

SREG = sreg;

}

ATmega128 Datasheet(PDF) 117 Page - ATMEL Corporation

ATmega128 Datasheet(HTML) 117 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL