ATmega16U4 datasheet(133/408 Pages) ATMEL

133 / 408 page

133

7766D–AVR–01/09

ATmega16U4/ATmega32U4

This bit selects which edge on the Input Capture Pin (ICPn) that is used to trigger a capture

event. When the ICESn bit is written to zero, a falling (negative) edge is used as trigger, and

when the ICESn bit is written to one, a rising (positive) edge will trigger the capture.

When a capture is triggered according to the ICESn setting, the counter value is copied into the

Input Capture Register (ICRn). The event will also set the Input Capture Flag (ICFn), and this

can be used to cause an Input Capture Interrupt, if this interrupt is enabled.

When the ICRn is used as TOP value (see description of the WGMn3:0 bits located in the

TCCRnA and the TCCRnB Register), the ICPn is disconnected and consequently the input cap-

ture function is disabled.

• Bit 5 – Reserved Bit

This bit is reserved for future use. For ensuring compatibility with future devices, this bit must be

written to zero when TCCRnB is written.

• Bit 4:3 – WGMn3:2: Waveform Generation Mode

See TCCRnA Register description.

• Bit 2:0 – CSn2:0: Clock Select

The three clock select bits select the clock source to be used by the Timer/Counter, see Figure

13-8 and Figure 13-9.

ATmega16U4 Datasheet(PDF) 133 Page - ATMEL Corporation