ATmega328P datasheet(182/345 Pages) ATMEL

182 / 345 page

182

7810A–AVR–11/09

ATmega328P [Preliminary]

19.8

Asynchronous Data Reception

The USART includes a clock recovery and a data recovery unit for handling asynchronous data

reception. The clock recovery logic is used for synchronizing the internally generated baud rate

clock to the incoming asynchronous serial frames at the RxDn pin. The data recovery logic sam-

ples and low pass filters each incoming bit, thereby improving the noise immunity of the

Receiver. The asynchronous reception operational range depends on the accuracy of the inter-

nal baud rate clock, the rate of the incoming frames, and the frame size in number of bits.

19.8.1

Asynchronous Clock Recovery

The clock recovery logic synchronizes internal clock to the incoming serial frames. Figure 19-5

illustrates the sampling process of the start bit of an incoming frame. The sample rate is 16 times

the baud rate for Normal mode, and eight times the baud rate for Double Speed mode. The hor-

izontal arrows illustrate the synchronization variation due to the sampling process. Note the

larger time variation when using the Double Speed mode (U2Xn = 1) of operation. Samples

denoted zero are samples done when the RxDn line is idle (i.e., no communication activity).

Figure 19-5. Start Bit Sampling

When the clock recovery logic detects a high (idle) to low (start) transition on the RxDn line, the

start bit detection sequence is initiated. Let sample 1 denote the first zero-sample as shown in

the figure. The clock recovery logic then uses samples 8, 9, and 10 for Normal mode, and sam-

ples 4, 5, and 6 for Double Speed mode (indicated with sample numbers inside boxes on the

figure), to decide if a valid start bit is received. If two or more of these three samples have logical

high levels (the majority wins), the start bit is rejected as a noise spike and the Receiver starts

looking for the next high to low-transition. If however, a valid start bit is detected, the clock recov-

ery logic is synchronized and the data recovery can begin. The synchronization process is

repeated for each start bit.

19.8.2

Asynchronous Data Recovery

When the receiver clock is synchronized to the start bit, the data recovery can begin. The data

recovery unit uses a state machine that has 16 states for each bit in Normal mode and eight

states for each bit in Double Speed mode. Figure 19-6 shows the sampling of the data bits and

the parity bit. Each of the samples is given a number that is equal to the state of the recovery

unit.

START

IDLE

BIT 0

123

678

RxD

Sample

(U2X = 0)

Sample

(U2X = 1)

ATmega328P Datasheet(PDF) 182 Page - ATMEL Corporation

ATmega328P Datasheet(HTML) 182 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL