PESDXS5UD_SER_2

© NXP B.V. 2006. All rights reserved.

Product data sheet

Rev. 02 — 7 December 2006

8 of 13

NXP Semiconductors

PESDxS5UD series

Fivefold ESD protection diode arrays

7.

Application information

The PESDxS5UD series is designed for the protection of up to five unidirectional data

lines from the damage caused by ESD and surge pulses. The PESDxS5UD series may be

used on lines where the signal polarities are both, positive and negative with respect to

ground. The PESDxS5UD series provides a surge capability of 200 W per line for an

8/20

µs waveform.

Circuit board layout and protection device placement

Circuit board layout is critical for the suppression of ESD, Electrical Fast Transient (EFT)

and surge transients. The following guidelines are recommended:

1. Place the PESDxS5UD as close to the input terminal or connector as possible.

2. The path length between the PESDxS5UD and the protected line should be

minimized.

3. Keep parallel signal paths to a minimum.

4. Avoid running protected conductors in parallel with unprotected conductors.

5. Minimize all Printed-Circuit Board (PCB) conductive loops including power and

ground loops.

6. Minimize the length of the transient return path to ground.

7. Avoid using shared transient return paths to a common ground point.

8. Ground planes should be used whenever possible. For multilayer PCBs, use ground

vias.

Fig 10. Application diagram

6

5

4

1

2

3

006aaa019

PESDxS5UD

high-speed

data lines

unidirectional protection of 5 lines

6

5

4

1

2

3

PESDxS5UD

bidirectional protection of 4 lines