4 / 6 page

Preliminary
2-272
RF3117
Rev A0 011016
2
Pin
Function
Description
Interface Schematic
1
VCC1
First stage collector supply. A low frequency decoupling capacitor (e.g.,
4.7
µF) is required.
2RF IN
RF input internally matched to 50
Ω. This input is internally AC-coupled.
3VREG
Regulated voltage supply for amplifier bias. In Power Down mode, both
VREG and VMODE need to be LOW (<0.5V).
4VMODE
For nominal operation (High Power Mode), VMODE is set LOW. When
set HIGH, devices are turned off to improve efficiency.
5
VCC2
Output stage collector supply. A low frequency decoupling capacitor
(e.g., 4.7
µF) is required.
6RF OUT
RF output internally matched to 50
Ω. This output is internally AC-cou-
pled.
7GND
Ground connection. Connect to package base ground. For best perfor-
mance, keep traces physically short and connect immediately to
ground plane.
Pkg
Base
GND
Ground connection. The backside of the package should be soldered to
a top side ground pad which is connected to the ground plane with mul-
tiple vias. The pad should have a short thermal path to the ground
plane.