Synthesizer, SMT for RFID

Covering all UHF Bands

Rev. V2

MASY-007028-000100

• North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400

• India Tel: +91.80.4155721

• China Tel: +86.21.2407.1588

Visit www.macomtech.com for additional data sheets and product information.

M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make

changes to the product(s) or information contained herein without notice.

3

ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions

is considering for development. Performance is based on target specifications, simulated results,

and/or prototype measurements. Commitment to develop is not guaranteed.

PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology

Solutions has under development. Performance is based on engineering tests. Specifications are

typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.

Commitment to produce in volume is not guaranteed.

Electrical Specifications – Japanese Band

Parameter

Test Conditions

Units

Min

Typ

Max

Frequency Range

Japanese Band

MHz

952

-

954

Frequency Stability

6

ppm

-

-

10

RF Output Power

At 25

°C

6

dBm

dBm

+4.0

+3.0

-

+6.2

+7.5

Phase Noise

SSB at 100 Hz offset from carrier

SSB at 1 KHz offset from carrier

SSB at 10 KHz offset from carrier

SSB at 100 KHz offset from carrier

SSB at 200 KHz offset from carrier

SSB at 1 MHz offset from carrier

SSB at 2 MHz offset from carrier

SSB at 3 MHz offset from carrier

dBc/Hz

dBc/Hz

dBc/Hz

dBc/Hz

dBc/Hz

dBc/Hz

dBc/Hz

dBc/Hz

-

-

-

-

-

-

-

-

-74

-76

-81

-113

-120

-134

-136

-142

-

-

-

-

-

-

-

-

Phase Jitter

From 10 kHz to 100 kHz using brick wall filter

deg rms

-

0.34

-

Harmonic Suppression

2nd

3rd and higher

1.25 * Fo

1.5 * Fo

Sub-harmonics

dBc

dBc

dBc

dBc

dBc

-

-

-

-

-

-35

-35

-80

-85

-80

-20

-25

-60

-60

-60

Spurious Suppression

(Non-Harmonic)

Phase comparison frequency

( ± 200 KHz)

dBc

-

-75

-

Spurious Suppression

(Non-Harmonic)

Reference breakthrough ( ± 16 MHz)

dBc

-

-80

-

Frequency Lock Time

Over Fout, PFD frequency = 200 KHz,

Loop bandwidth = 5 KHz

Measured to within ± 1 kHz

Measured to within ± 10 Hz

us

us

-

-

700

800

-

-

VDD1

7

Recommended Operating Condition

V

+3.00

+3.30

+3.45

IDD1

10

Recommended Operating Condition

mA

-

45

60

VDD2

8

Recommended Operating Condition

V

+3.00

+3.30

+3.45

IDD2

Recommended Operating Condition

mA

-

20

35

RF Impedance

At RX_LO and TX_LO

9

Ω

-

50

-

Isolation

Between RX_LO and TX_LO

dB

-

20

-

Step Size

6

KHz

-

200

-

Output Frequencies

For Japanese RFID readers, there are 9 equally spaced

frequencies. The minimum and maximum frequencies are to the

right. There are 8 steps with a step size of 200 KHz.

MHz

952.200

-

953.800

PLL Programming

3-wire serial CMOS in accordance with Analog Devices ADF4360-7.

5.

All specification limits are indicated values @ 25°C and apply over Fout unless otherwise indicated.

6.

Top = -30°C to +70°C operating temperature.

7.

VDD1 is the bias for the TCXO, VCO, and the synthesizer.

8.

VDD2 is the bias for the amplifier.

9.

Opposite port is terminated in 50 ohms.

10. IDD1 includes approximately 10 mA which drives an optional external Lock Detector LED.