SFP Ganged Press-Fit PT Connector and Cage Assembly

114-13121

Rev A

2 of 10

Figure 1 (end)

Connector

Cage Assembly

Compliant Pin

Contacts

Housing

Card Entry

Slot

Alignment Post

(2 Places)

Panel Ground

Springs (24 Places)

Module

Locking Latch

Compliant Pin

Contacts

Thermal

Vent Holes

Kick-Out Spring

(4 Places)

Port (4 Places)

Frame

Standoffs

Standoff

2. REFERENCE MATERIAL

2.1. Revision Summary

2.2. Customer Assistance

Reference Product Base Part Number 1658706 and Product Code K221 are representative numbers of the

SFP Ganged Press–Fit PT Connector and Cage Assembly. Use of these numbers will identify the product line

and expedite your inquiries through a service network established to help you obtain product and tooling

information. Such information can be obtained through a local Tyco Electronics Representative or, after

purchase, by calling PRODUCT INFORMATION at the number at the bottom of page 1.

2.3. Drawings

Customer Drawings for product part numbers are available from the service network. If there is a conflict

between the information contained in the Customer Drawings and this specification or with any other technical

documentation supplied, the information contained in the Customer Drawings takes priority.

2.4. Specifications

Product Specification 108–2161 provides product performance and test information for the SFP Ganged

Press–Fit PT Connector and Cage Assembly.

2.5. Instructional Material

Instruction Sheets (408–series) provide product assembly instructions or tooling setup and operation

procedures. Documents available which pertain to this product are:

Document Number

Document Title

408–8848

SFP PT Connector and Cage Assembly Seating Tool Kits

408–8849

SFP Cage Assembly Extraction Tools

408–8850

SFP PT Connector Extraction Tool 1725480–2