1489948-1 datasheet(2/3 Pages) MACOM

2 / 3 page

408-8723

2 of 3

Rev B

Figure 3

3. Place the host pc board on the pc board

support fixture.

A pc board support fixture must be used to provide

proper support for the host pc board, and to prevent

damage to the host pc board and its adjacent

components.

4. Align the compliant pins of the cage assembly

with the applicable holes in the host pc board.

Using even pressure across the cage assembly,

apply only that force necessary to seat the

shoulders of the compliant pins onto the host pc

board. Then remove the pc board support fixture.

5. Inspect the seated cage assembly according to

Figure 4.

6. Design the bezel according to 114-13096.

It is recommended that an EMI gasket be installed

onto the back of the bezel. Follow the design

requirements for the gasket also given in

114-13096.

Figure 4

7. Mount the cage assembly (with the host pc

board) onto the bezel. Make sure that the

opening of the cage assembly is centered over

the cutout of the bezel and that the front flange is

against the EMI gasket. See Figure 5.

To avoid interference with the insertion and

extraction of the transceiver, IT IS IMPORTANT

that the bezel and pc board be positioned in

relation to each other according to Figure 5.

Figure 5

Connector

Host PC Board

CAUTION

NOTE

Lower Rear Gasket

Fully Seated on

Host PC Board

There is No Damage

or Distortion to

Cage Assembly

0.05 mm (Max)

Shoulder of Compliant

Pin Seated on Host

PC Board

Cage Assembly Front

Flange Does Not

Touch Host PC Board

Host PC Board

CAUTION

EMI Gasket

(Ref)

Front Flange

5.2 mm Max

Cutout in

Bezel

Host PC Board

0.3±0.2 mm For Bezel Cutout Above Host PC Board

0.4±0.1 mm For Peripheral Component

Interconnect (PCI) Application

0.3±0.2 mm For Bezel Cutout

Above Host PC Board

Note: Dimensions and

References for Mounting

to One Side of PC Board

Also Apply

Cage Assembly Installed onto Bezel

Side View

Mounting Connector and Cage Assembly to

One Side of Host PC Board

Mounting Connector and Cage Assembly to

Both Sides of Host PC Board

Cage

Assembly

1489948-1 Datasheet(PDF) 2 Page - Tyco Electronics

1489948-1 Datasheet(HTML) 2 Page - Tyco Electronics

Html Pages

1 2 3

Datasheet Download

Link URL