AD7813

–9–

REV. B

PARALLEL INTERFACE

The parallel interface of the AD7813 is eight bits wide. The

output data buffers are activated when both

CS and RD are

logic low. At this point the contents of the data register are

placed on the 8-bit data bus. Figure 15 shows the timing dia-

gram for the parallel port. As previously explained, two succes-

sive read operations must take place in order to access the 10-bit

conversion result. The first read places the 8 MSBs on the data

bus and the second read places the 2 LSBs on the data bus. The

2 LSBs appear on DB7 and DB6, with DB5–DB0 set to logic zero.

Further read operations will access the 8 MSBs and 2 LSBs of

the 10-bit ADC conversion result again. The parallel interface

of the AD7813 is reset when BUSY goes logic high. This feature

allows the AD7813 to be used as an 8-bit converter if the user

only wishes to access the 8 MSBs of the conversion. Care must

be taken to ensure that a read operation does not occur while

BUSY is high. Data read from the AD7813 while BUSY is high

will be invalid. For optimum performance the read operation

next

CONVST.

8 MSBs

EXT

CONVST

INT

CONVST

BUSY

CS/RD

DB7–DB0

2 LSBs

Figure 13. Mode 1 Operation

8 MSBs

EXT

CONVST

INT

CONVST

BUSY

CS/RD

DB7–DB0

Figure 14. Mode 2 Operation

CONVST

BUSY

CS

DB7–DB0

RD

8 MSBs

2 MSBs

Figure 15. Parallel Port Timing