0622016250 datasheet(9/23 Pages) MOLEX11

9 / 23 page

VHDM and VHDM-HSD*

*VHDM and VHDM HSD are Trademark of Teradyne, Inc

Doc. No: TM-622010999

Release Date: 08-10-99

UNCONTROLLED COPY

Page 9 of 23

Revision: H

Revision Date: 03-15-10

Figure 2-4

TYPICAL INSERTION TOOL ASSEMBLY

Figure 2-3

MOUNTING INSERT MODULE

IN A MOUNTING BLOCK

TYPICAL

INSERTION MODULES

HOLDER

Figure 2-5

ALIGNING TERMINAL

PINS TO HOLES

Figure 2-6

CONNECTOR ASSEMBLY

ON PC BOARD SUPPORT PALLET

SUPPORT PALLET

LOCATING PIN

LOCATING

PC BOARD

CONNECTOR

ASSEMBLY

Figure 2-7

TYPICAL HEADER ASSEMBLY

ON THE PC BOARD

PC BOARD

PRES-IN TOOLING

SUPPORT

PALLET

3. Now tighten the M3 set screws against the modules

with one (1) screw against each power module

inserter and each alignment block; and two (2)

screws evenly spaced on a 6 by 10 header insertion

module; and at least three (3) screws evenly spaced

on a 6 by 25 header insertion module. Figure 2-4

shows a typical completed assembly.

2.4 Operation

Header insertion Tooling

1. Carefully locate the connector(s) on the printed

circuit board and start in by hand. Make sure pin 1

is in the correct position on all connectors. See

Figure 2-5.

2. Locate the pre-loaded board into the support pallet.

See Figure 2-6.

3. Locate the tooling assembly in the connector

assembly, carefully checking alignment. See

Figure 2-7.

4. Position the pre loaded support pallet under the

press platen.

CAUTION: Do not over tighten the setscrews as

you could damage the insertion tool.

NOTE: See Section 4 for details on selecting

modules and mounting blocks.

5. Cycle the press. See Section 2.1 for press stroke

adjustment.

6. Remove the loaded support pallet.

7. Carefully remove the insertion tool assembly.

8. Remove the printed circuit board.

0622016250 Datasheet(PDF) 9 Page - Molex Electronics Ltd.

0622016250 Datasheet(HTML) 9 Page - Molex Electronics Ltd.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Datasheet Download

Link URL