ACT7006 datasheet(16/29 Pages) AEROFLEX

16 / 29 page

Aeroflex Circuit Technology

SCD7005 REV B 8/2/01

Plainview NY (516) 694-6700

Operation

Function

RESET

RESET INPUT/OUTPUT BUFFERS

This command clears both the input and output FIFO buffers. The BUFF EF

flag will go low indicating the output buffer is empty.

READ OUTPUT

DATA BUFFER

READ OUTPUT FIFO

READS the data moved from the INTERNAL RAM in response to an

UNLOAD execute operation. The order of the data words corresponds to the

same order that they would be received on the 1553B bus. That is the first

data word read is the first data word following the COMMAND word. In the 8

bit mode the HIGH BYTE is read FIRST.

WRITE OUTPUT

DATA BUFFER

WRITE INPUT FIFO

WRITES the data that will be moved into the INTERNAL RAM in response to

a LOAD execute operation. The order of the data words corresponds to the

same order that they would be transmitted on the 1553B bus. That is the first

data word written is the first data word transmitted following the status word. In

8 bit mode the HIGH BYTE is written FIRST.

EXECUTE OP

EXECUTES OPERATION SPECIFIED IN OPERATION REGISTER

1. I/O BIT HIGH

Data currently in INPUT FIFO BUFFER is loaded into the INTERNAL

RAM block specified by the T/R BIT and SUBADDRESS FIELD of the

OPERATION REGISTER. The INPUT BUFFER must have at least one

data word. The DONE interrupt is pulsed when the operation is

completed.

2. I/O BIT LOW

An entire block of data (32 words) specified by the T/R and the

SUBADDRESS field of the OPERATION REGISTER is unloaded from

the INTERNAL RAM into the OUTPUT FIFO BUFFER. The BUFF EF

Flag goes high when the first data word is moved into the OUTPUT

BUFFER. The DONE interrupt is pulsed when the complete message

has been moved.

EXECUTE OP

WITH RPT OPTION

EXECUTES OPERATION SPECIFIED IN OPERATION REGISTER WITH

REPEAT OPTION

1. I/O BIT HIGH

Data previously written into the INPUT BUFFER is loaded into a new

INTERNAL RAM block specified by the T/R and SUBADDRESS field of

the OPERATION REGISTER. This operation allows a block of data

loaded in the INPUT BUFFER to be repeatedly copied into multiple

subaddresses of the INTERNAL RAM without the subsystem having to

reload the data. The DONE interrupt is pulsed when the operation is

completed. The intent of the operation is to minimize the time required to

initialize the INTERNAL RAM.

I/O BIT LOW

Operation identical to EXECUTE OP. WITHOUT RPT option.

TRIGGER TRANSACTION

TRIGGER TEST

TRANSACTION/TEST TRIGGER

This signal executes the desired Bus Controller Function or test of the

protocol section determined by the Operation Register.

Table 8 – Non-Register Operational Commands

ACT7006 Datasheet(PDF) 16 Page - Aeroflex Circuit Technology

ACT7006 Datasheet(HTML) 16 Page - Aeroflex Circuit Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29

Datasheet Download

Link URL