69097 datasheet(3/8 Pages) ETC2

3 / 8 page

408- 1697

of 8

Rev C

Figure 4

Terminals

End of Conductor is Flush

or Extended Slightly Beyond

Endof WireBarrel

Center Terminal

Barrel in

Stationary Die

Brazed Seam Faces Moving Die

Ensure that the wire size stamped on the terminal

or splice corresponds with the wire size stamped

on the stationary die. Crimping head 69099 is

shown in Figures 3 thru 6. The crimping procedure

is identical when using crimping head 69097.

1. Place the terminal or splice in the stationary die

as shown in Figures 4, 5, or 6. For best results,

position the terminal or splice so that the brazed

seam faces the moving die.

2. Activate the power unit so that the crimping die

advances and holds the terminal or splice in place.

Do not deform the terminal or splice barrel.

3. Insert the stripped wire all the way into the

terminal or splice barrel.

4. Activate the power unit to complete the crimp.

5. To crimp the other half of the butt splice, remove

and reposition the uncrimped half in the stationary

die. Insert the wire and crimp the splice.

6. Refer to Section 3, CRIMP INSPECTION and

Figure 7 for crimp inspection information.

If SOLISTRAND terminals or splices stick in the

die after crimping, apply a rocking motion to

remove them from the die.

Figure 5

Butt Splices

Brazed Seam

Faces Moving

Die

Center Half of

Butt Splice in

Stationary Die

End of Conductor Butts

Against Splice Wire Stop

Figure 6

Parallel Splices

Center Parallel Splice

Barrel in Stationary Die

Center Parallel

Splice Barrel in

Stationary Die

Brazed Seam Faces Moving Die

End of Conductor is

Flush or Extended

Slightly Beyond

Endof WireBarrel

End of Conductor is Flush

or Extended Slightly Beyond

Endof WireBarrel

Brazed Seam

Faces Moving Die

NOTE

69097 Datasheet(PDF) 3 Page - List of Unclassifed Manufacturers

69097 Datasheet(HTML) 3 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8

Datasheet Download

Link URL