Product and Company names and logos referenced may either be trademarks or registered trademarks of their respective companies. All information is correct at time of

issue. Telegesis reserves the right to make modifications and/or improvements without prior notification. Telegesis does not convey any license under its patent rights or

assume any responsibility for the use of the described product.

© 2008 Telegesis

ZigBee Technology ETRX2 based products

www.telegesis.com

EAP-E - Ethernet Access Point (below)

To accompany the Telegesis ETRX2 wireless mesh networking

modules the EAP-E Ethernet Access Points offer an easy way to

interact with remote ZigBee networks using Ethernet.

Via Telnet, or a virtual COM port, the Telegesis AT-Command

interface - based on the EmberZNet meshing stack - can be

easily accessed by the application software. Custom firmware

development is also supported.

ETRX2DVKA - Development Kit (below)

This ETRX2 Development Kit provides genuine quick and easy,

out-of-the-box construction of a working mesh network. Using the

comprehensive AT-style Command Dictionary and the simple to

use Telegesis Terminal software package provided, it should take

less than half an hour to set up a three-way mesh network and to

begin detailed, in-depth assessment of the latest EmberZNet

meshing technology. Kit includes three ETRX2 modules.

New Module Carrier Boards now have temperature and light

sensor plus SIF interface.

Router-E (above)

To accompany the Telegesis ETRX2 wireless mesh networking

modules the Router-E offers an easy way to extend the range of

ZigBee networks. Acts as a “router” which enables increased

distance between nodes in a ZigBee network.

ETRX2DVKA-Plus - upgraded Development Kit (above)

The Development Kit provides genuine quick and easy, out-of-

the-box evaluation and application development, based on the

Telegesis wireless meshing modules. Kit contents as per

ETRX2DVKA Plus:-



ZigBee USB stick



Power amplified module mounted on carrier board



Power amplified module with external antenna connector



½ wave antenna and cable for above

Experiment using the power amplified ETRX2-PA modules with

their greatly extended range.

ETRX2CF - CF Card

Telegesis has used the ETRX2 Module to

provide a portable handheld unit able to

communicate with other modules in the

field.

Can be used in a PDA with a CF slot or in a

laptop computer with a PCMCIA/CF

adaptor. Contains an ETRX2 module and

therefore all the usual Telegesis AT-style

Commands available via a virtual com port.

ETRX2-PA - Power Amplified Mesh Module

The Telegesis ETRX2-PA offers boosted output power whilst

being a drop in replacement for the standard ETRX2. Care was

taken to retain the low deep sleep current to make this module

ideally suited for battery operated end devices with the lowest

transmit current in its class.

ETRX2USB - USB Stick

Based on the ETRX2 module, the

USB stick allows a PC/Server to

monitor and control devices in a

ZigBee network. The USB stick acts

as a virtual com port in Windows and

is controlled by the Telegesis AT-

Style Commands.