AD8007AKS-R2 datasheet(17/21 Pages) AD

17 / 21 page

AD8007/AD8008

Rev. E | Page 16 of

Whenever physical layout considerations prevent the decoupling

scheme shown in Figure 53, the user can connect one of the

high frequency decoupling capacitors directly across the supplies

and connect the other high frequency decoupling capacitor to

ground (see Figure 54).

+VS

–VS

499Ω

200Ω

499Ω

OUT

AD8007

10µF

0.1µF

Figure 54. High Frequency Capacitors Connected Across the Supplies

(Recommended)

LAYOUT CONSIDERATIONS

The standard noninverting configuration with recommended

power supply bypassing is shown in Figure 54. The 0.1 μF high

frequency decoupling capacitors should be X7R or NPO chip

components. Connect C2 from the +VS pin to the −VS pin.

Connect C1 from the +VS pin to signal ground.

The length of the high frequency bypass capacitor leads is critical.

Parasitic inductance due to long leads works against the low

impedance created by the bypass capacitor. The ground for the

load impedance should be at the same physical location as the

bypass capacitor grounds. For larger value capacitors, which are

intended to be effective at lower frequencies, the current return

path distance is less critical.

AD8007AKS-R2 Datasheet(PDF) 17 Page - Analog Devices