TLV5535

8-BIT, 35 MSPS, LOW-POWER ANALOG-TO-DIGITAL CONVERTER

SLAS221 – JUNE 1999

7

POST OFFICE BOX 655303

voltage references (unless otherwise noted) (continued)

timing requirements

PARAMETER

TEST CONDITIONS

MIN

TYP

MAX

UNIT

fCLK

Maximum conversion rate

35

MHz

fCLK

Minimum conversion rate

10

kHz

td(o)

Output delay time (see Figure 1)

CL = 10 pF,

See Notes 5 and 6

9

ns

th(o)

Output hold time

CL = 2 pF,

See Note 5

2

ns

td(pipe)

Pipeline delay time (latency)

See Note 6

4.5

4.5

4.5

CLK

cycles

td(a)

Aperture delay time

3

ns

tj(a)

Aperture jitter

See Note 5

1.5

ps, rms

tdis

Disable time, OE rising to Hi-Z

See Note 5

5

8

ns

ten

Enable time, OE falling to valid data

5

8

ns

NOTES:

5. Output timing td(o) is measured from the 1.5 V level of the CLK input falling edge to the 10%/90% level of the digital output. The digital

output load is not higher than 10 pF.

Output hold time th(o) is measured from the 1.5 V level of the CLK input falling edge to the 10%/90% level of the digital output. The

digital output is load is not less than 2 pF.

Aperture delay td(A) is measured from the 1.5 V level of the CLK input to the actual sampling instant.

The OE signal is asynchronous.

OE timing tdis is measured from the VIH(MIN) level of OE to the high-impedance state of the output data. The digital output load is

not higher than 10 pF.

OE timing ten is measured from the VIL(MAX) level of OE to the instant when the output data reaches VOH(min) or VOL(max) output

levels. The digital output load is not higher than 10 pF.

6. The number of clock cycles between conversion initiation on an input sample and the corresponding output data being made

available from the ADC pipeline. Once the data pipeline is full, new valid output data is provided on every clock cycle. In order to

know when data is stable on the output pins, the output delay time td(o) (i.e., the delay time through the digital output buffers) needs

to be added to the pipeline latency. Note that since the max td(o) is more than 1/2 clock period at 35 MHz, data cannot be reliably

clocked in on a rising edge of CLK at this speed. The falling edge should be used.