| Electronic Components Datasheet Search |
|
MAX192BCAP Datasheet(PDF) 12 Page - Maxim Integrated Products |
|
|
|||||||||||||||||||||||||||||
MAX192BCAP Datasheet(HTML) 12 Page - Maxim Integrated Products |
|
12 / 24 page ![]() Low-Power, 8-Channel, Serial 10-Bit ADC 12 ______________________________________________________________________________________ SSTRB CS SCLK DIN DOUT 1 4 8 12 16 20 24 START SEL2 SEL1 SEL0 UNI/ BIP SGL/ DIF PD1 PD0 B9 MSB B8 B7 B6 B5 B4 B3 B2 B1 B0 LSB S1 SO ACQUISITION 1.5µs (CLK = 2MHz) IDLE FILLED WITH ZEROS IDLE CONVERSION tACQ A/D STATE RB1 RB1 RB2 RB3 RB2 RB3 • • • • • • • • • • • • CS SCLK DIN DOUT tCSH tCSS tCL tDS tDH tDV tCH tDO tTR tCSH Figure 6. 24-Bit External Clock Mode Conversion Timing (SPI, QSPI and Microwire Compatible) Figure 7. Detailed Serial-Interface Timing Pulling CS high prevents data from being clocked into the MAX192 and three-states DOUT, but it does not adversely affect an internal clock-mode conversion already in progress. When internal clock mode is selected, SSTRB does not go into a high-impedance state when CS goes high. Figure 10 shows the SSTRB timing in internal clock mode. In internal clock mode, data can be shifted in and out of the MAX192 at clock rates exceeding 4.0MHz, provided that the minimum acquisition time, tAZ, is kept above 1.5µs. Data Framing The falling edge of CS does not start a conversion on the MAX192. The first logic high clocked into DIN is inter- preted as a start bit and defines the first bit of the control byte. A conversion starts on the falling edge of SCLK, after the eighth bit of the control byte (the PD0 bit) is clocked into DIN. The start bit is defined as: The first high bit clocked into DIN with CS low any- time the converter is idle, e.g. after VDD is applied. OR The first high bit clocked into DIN after bit 3 of a conversion in progress is clocked onto the DOUT pin. If a falling edge on CS forces a start bit before bit 3 (B3) becomes available, then the current conversion will be terminated and a new one started. Thus, the fastest the MAX192 can run is 15 clocks per conver- sion. Figure 11a shows the serial-interface timing nec- essary to perform a conversion every 15 SCLK cycles in external clock mode. If CS is low and SCLK is contin- uous, guarantee a start bit by first clocking in 16 zeros. |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |