All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).

All specifications are to the latest revisions. Specifications are subject to change without notice.

Registered trademarks are the property of their respective companies. Made in USA

7/10/02 SY/EH/LS

PomonaACCESS 90739 (800) 444-6785 or (425) 446-6010

Last saved by Laura Goldberg

More drawings available at www.pomonaelectronics.com

C:\Laura Goldberg\FlukeDataSheet \d6372_6559-60-61_2_02.doc

Page 2 of 2

Model 6372, 6559, 6560, 6561

Male Mini-Connector

“Do-It-Yourself”

Sales:800-490-2361 Fax: 888-403-3360

Technical Assistance: 800-241-2060

ASSEMBLY INSTRUCTIONS

1.

Using a flat tip screwdriver, remove lid from connector.

2.

Cut back extension wire jacket (if applicable) 5/8”, strip back individual wires ¼”.

3.

Remove the elastomer strain relief from the connector. Insert wires into the strain relief until flush with the extension

wire outer jacket (5/8”).

4.

Loosen the two wire terminal screws (Approximately 3 ½ turns counter clockwise) using a small flat tip

screwdriver.

5.

Insert the stripped Red* wire under the (-) terminal screw, and the remaining wire under the (+) terminal screw.

Tighten down the two terminal screws.

6.

Install the lid and tighten down the lid screw.

*Color may vary outside of the USA.