RX220

Renesas Starter Kit Sample Code for CubeSuite+

R20AN0280EJ0100 Rev. 1.00

Page 5 of 6

Jan. 17, 2014

There are cases where the warning message shown below is output when the E1 emulator is started.

Ignore the message unless you will be using the timer measurement function.

If you will be using the timer measurement function, double-click on RX E1(Serial) (debug tool) to open the property

panel, select the [Debug Tool Settings] tab, then input 20 against [Operation Frequency [MHz]].

9.

Executing Programs

After downloading is complete, selecting [Debug] -> [Go] executes the program.