CS4396

20

DS288PP1

6.0 CONTROL PORT INTERFACE

The control port is used to load all the internal settings of the CS4396. The operation of the control port

may be completely asynchronous to the audio sample rate. However, to avoid potential interference prob-

lems, the control port pins should remain static if no operation is required.

transition on AD0/CS after power-up, SPI mode will be selected.

6.1 SPI Mode

In SPI mode, CS is the CS4396 chip select signal, CCLK is the control port bit clock, CDIN is the input

data line from the microcontroller, CDOUT is the data output and the chip address is 0010000. The data

is clocked on the rising edge of CCLK.

Figure 5 shows the operation of the control port in SPI mode. To write to a register, bring CS low. The first

7 bits on CDIN form the chip address, and must be 0010000. The eighth bit is a read/write indicator (R/W).

The next 8 bits form the Memory Address Pointer (MAP), which is set to 01h. The next 8 bits are the data

which will be placed into the register designated by the MAP.

with the clock to data relationship as shown in Figure 2. There is no CS pin. Pins AD0 and AD1 form the

partial chip address and should be tied to VD or DGND as required. The 7-bit address field, which is the

first byte sent to the CS4396, must be 00100(AD1)(AD0) where (AD1) and (AD0) match the setting of the

AD0 and AD1 pins. The eighth bit of the address byte is the R/W bit (high for a read, low for a write). If

the operation is a write, the next byte is the Memory Address Pointer, MAP, which selects the register to

be read or written. The MAP is then followed by the data to be written. If the operation is a read, then the

contents of the register pointed to by the MAP will be output after the chip address.

section.

Memory Address Pointer (MAP)

INCR (Auto MAP Increment Enable)

MAP0-2 (Memory Address Pointer)

Default = ‘0’

Default = ‘001’

0 - Disabled

1 - Enabled

765

4321

0

INCR

Reserved

Reserved

Reserved

Reserved

MAP2

MAP1

MAP0

000

0000

1