The copyright and authority for the interpretation of the products are reserved by MORNSUN

TCx00PI

2013.07.01-A/2

Page 2 of 4

ELECTRICAL SPECIFICATIONS

Power Supply

18~36VDC (Typ. : 24VDC)

Input Power

About 2.0W

Power Supply

Power Protection

Reverse protection

Input Signal

Refer to product overview

Compensation range: -25 ~ +75

°C (Every 20°C error of 1°C)

Hazardous Area

Cold junction compensation

Compensation mode: Internal compensation

Output Signal

Refer to product program

≤ 500Ω (@maximum output current)

Load

≥ 10KΩ (@maximum output voltage)

Communication Interface

RS485 Physical Bus Interface

Safe Area

Communication protocol

Refer to

”MORNSUN Science and Technology Modbus Protocol Rule”

TRANSMISSION SPECIFICATIONS

Offset

0.1%F.S.

Gain Error

0.1%F.S.

Plus Error

0.1%F.S.

Temperature Drift

0.0035%F.S./

°C (-25 ~ +71°C)

ISOLATION SPECIFICATIONS

2.5kVAC between control cabinet and application field (Tested for 1 minute and leakage current

≤1mA )

Galvanic isolation

1.5kVDC between power supply and output (Tested for 1 minute)

EMC

EN 61326

SURGE PROTECTION SPECIFICATIONS (

–SP SERIALS)

Maximum continuous operation voltage

30VDC

Rated discharge current

5KA (Line-to-ground, line-to-line)

Maximum discharge current

10KA (Line-to-ground)

Standard

GB18802. 21-2004

OTHER SPECIFICATIONS

Lower limit alarm

Below its lower limit of -5

°C (temperature signal) or -2mV (mV signal), output current about 3mA (4~20mA) or 21mA

(4~20mA), light

“ L” on

Upper limit alarm

Exceeding its upper limit of +5

°C (temperature signal) or +2mV (mV signal), output current about 22mA, light “ H” on

Break coupling alarm

Break coupling or input signal

≥ 70mV, output current about 23mA, light “O” on

Operation temperature: -25 ~ +60

°C

Ambient temperature

Transport and Storage temperature: -50 ~ +105

°C

Package

35mm DIN-rail package, pluggable connection terminal, thickness 22.5mm, Plastic UL94-V0

Safety Class

IP20(IEC60529 / EN60529)

Weight

About 123g

Note:

1. All specifications measured at TA=25

°C, humidity<75%, nominal input voltage and rated output load unless otherwise specified.

2. Only typical models listed, specifications of custom product may be different. Please contact our service people directly for certain conditions.

3. Communication protocol details refer to

”MORNSUN Science and Technology Modbus Protocol Rule”.

4. The MORNSUN Safety Barrier Configuration software can be downloaded free from the MORNSUN homepage www.mornsun.cn or you can contact us to get it.

CONNECTION

1. Rem ovable terminal;

2. Cross section area of wiring: 0.5mm

3. The length of bare wire is about 8mm, locked up by the M3 bolt.

4.

Application about Surge Protector

Connect the ground of protected equipment or case, and ground of surge protectors directly, and connecting wire is as short as possible. Single

point grounding can make surge protectors avoid high-voltage between surge protectors and the ground, which makes protection more effectively.

Operation notes

1. Please read the user manual carefully before using. If any questions please contact our technical support department.

2. Please do not use this product in hazardous area.

3. Power supply of this product should be 24VDC. 220VAC is prohibited.

4. To avoid explosion protection function invalid or any failure, disassem bling the product is forbidden.