Glass Fiber Installation

O-ring

Retaining Clip

1. Install the O-ring (supplied with the fiber) on each fiber end, as shown in the drawing.

2. While pressing the fiber ends firmly into the ports on the sensor front, slide the U-shaped retaining clip (supplied with the sensor) into the slot in the sensor’s barrel,

until it snaps into place.

Plastic Fiber Installation

Trimmed fiber

control ends

Plastic fiber

emitter port

Plastic fiber

receiver port

Gripper

Unlock

Lock

Adapters for

0.25- and 0.5-mm fibers

Sensor Face

1. With supplied fiber cutter, make a clean cut at control ends of fibers.

2. Unlock the fiber gripper as shown below. Apply appropriate fiber adaptors prior to fiber insertion, if needed.

3. Gently insert the prepared fiber ends into the ports, as far as they will go.

4. Slide the fiber gripper back to lock, as shown below.

MINI-BEAM dc-Voltage Series

P/N 69943 rev. C

www.bannerengineering.com - tel: 763-544-3164

5