Data Sheet

GPS100

SPEC No.

GPS100

Revision

A 1

State

02.06.2005

C-MAX printed

03.05.2007

Version

English

Page

2 of 4

The GPS receiver GPS100 is a GPS receiver specially designed for the use with the TSG800

time signal generator. The GPS100 delivers exact time information synchronized via Satellite

to the connected application.

1.

GPS Synchronization with TSG800

The GPS mode will allow different operating options. Available are the options “Sync sec”

and “Sync Time”. If “Sync sec” is set to ON, the change over of the second is adjusted

exactly to the change over of the second of UTC time. If this feature has successfully

finished,

will be displayed in the upper right corner of the display. If, in addition, “Sync

Time” is set to ON, the time that is supplied by the GPS receiver will be calculated into local

time (exception: WWVB) and be transmitted as time and date. The calculation will also take

possible summer time settings into consideration. If the GPS receiver is connected, the

recently transmitted values of the second will be displayed. If the GPS receiver is not

connected XX will be displayed in the same position.

To start the GPS SYNC., push “GPS SYNC”

button and connect the C-MAX “GPS100” unit by

using the RJ45 GPS/SYNC. connector at the left

side of the front panel.