Tasking ST10 toolchain

AN2142

12/16

1.6

Using the RAM Monitor to debug the application with Cross

View debugger

Cross View debugger provides a high level interface between the user and a program running

in the target system (execution environment).

Cross View debugger runs on a PC computer and is connected to the ST10F27x target

microcontroller via an RS232 interface.

The connection to the target and the debug of the application require that you have successfully

compiled and built your application.

The monitor requires an external RAM memory to run. This RAM memory must be selected at

reset.

●

External RAM Chip select should be active

●

Make sure that ROMEN bit in SYSCON register is cleared (Internal ROM is disabled)

●

Enter the bootstrap loader mode by forcing P0L.4 to 0 at reset