Double Boost output supports momentary start-up loads up to 200% of the continuous rating for up to 10 seconds (see specification chart) - OverPower

output supports longer duration overloads to 150% for up to 60 seconds

3-stage, selectable 23/90 amp battery charger with adjustable settings for wet/gel battery types

3-position operating mode switch supports "AUTO" mode to enable automatic transfer between DC and AC modes, CHARGE-ONLY to maintain a full

battery charge when AC is present without auto transfer and SYSTEM OFF settings

Set of 6 front panel LEDs display continuous status information

Set of 4 dip switches support AC input selection of 230V, selectable 50 /60Hz frequency, and selectable full or half cycle transfer times

Set of 4 dip switches support wet/gel battery charging profiles, adjustable 260/270V (230V) high voltage auto transfer during overvoltages and selectable

150/60V / 170/180V (230V) AC low voltage auto transfer during brownouts

Set of 4 additional dip switches support battery equalization program and battery charger low / high settings

Automatic overload and thermal (overheating) shutoff

Front panel remote control connector enables remote off/on switching (APSRM4 sold separately)

Load sensing control dial enables adjustable load threshold required to automatically turn the inverter on and off in DC mode as load conditions change

Automatic Generator Starter jack enables user configuration of automatic generator start-up as inverter batteries drop to 23.0 VDC and generator shutoff

as inverter batteries are recharged to 28.2 VDC.

Remote battery temperature sensing connection function prolongs battery life by adjusting the charge float voltage level based on battery temperature

Specifications

OUTPUT

Frequency Compatibility

50 / 60 Hz

Output Receptacles

Hardwire

Output (Watts)

3000

Continuous Output Capacity (Watts)

3000

Peak Output Capacity (Watts)

6000

Output Nominal Voltage

230V

Output Voltage Regulation

LINE POWER (AC): Maintains 230V nominal sine wave output from line power source. INVERTER POWER (AC):

Maintains sine wave output voltage of 230 VAC (+/-5%).

Output Frequency Regulation

50/60 Hz (+/- 0.3 Hz)

Pure Sine Wave Output

Yes

INPUT

Nominal Input Voltage(s) Supported

230V AC

Recommended Electrical Service

DC INPUT: Requires 24VDC input source capable of delivering 145A for the required duration (when used at full

continuous capacity - DC requirements increase during OverPower and DoubleBoost operation).

Maximum Input Amps

28

Input Connection Type

DC INPUT: Set of DC bolt-down terminals. AC INPUT: Hardwire via built in terminal strip with cover plate

Voltage Compatibility (VAC)

230

Voltage Compatibility (VDC)

24

2 / 4