9.5 Cleaning/ 清洗

It is recommended that isopropyl alcohol be used as a solvent for cleaning the LEDs. It

should be confirmed beforehand whether the solvents will dissolve the package the resin or not

when using other solvents. Before cleaning, a pre-test should be done to confirm whether any

damage to the LEDs will occur. Please do not clean the LEDs by the ultrasonic.

建议使用酒精作为溶剂清洗LED。若要使用其他溶剂，应该预先证实是否能溶化封装

料。在清洗作业前，必须预先实验确认对LEDS无任何的伤害。请不要使用超声波清洗LED。

9.6 Static Electricity/ 静电

It is recommended that a wrist band or an anti-electrostatic glove be used when handling the

LEDs. All devices, equipment and machinery must be properly grounded. It is recommended that

precautions be taken against surge voltage to the equipment that mounts the LEDs.

在接触LED时，建议使用防静电手腕带或防静电手套。所有的器件、设备和机器必须

有可靠的接地。对所有LED接触的设备，建议采取预防措施消除冲击电压。

9.7 Others/ 其他

1. The LED light output is strong enough to injure human eyes. Precautions must be taken

to prevent looking directly at the LEDs with unaided eyes for more than a few seconds.

LED的光辐射足够强时，会对人眼造成伤害。若眼睛要直接看LED，并且要一定的时

间，则必须采取相应防护措施。

2. LED operating environment and sulfur element composition cannot be over 100PPM in

the LED mating usage material.

LED工作环境及与LED适配的材料中硫元素及化合物成份不可超过100PPM。

3. Not suitable to operate in acidic environment, PH<7

LED不可用在PH<7的酸性环境。

4. When we need to use external glue for LED application products, please make sure that

the external gluematches the LED packaging glue. Additionally ,as most of LED packaging glue

is silica gel, and it has strong Oxygen permeability as well as strong moisture permeability; in

order to prevent external material from getting into the inside of LED, which may cause the

Part No./型号:PLCC2LW6 CT

SMD SPECIFICATION

Hebei I.T. (Shanghai) Co., Ltd.

Http：

Page 11 of 12

// www.ledz.com