AX-SIGFOX datasheet(21/30 Pages) ONSEMI

21 / 30 page

Command Interface

www.onsemi.com

AX-SIGFOX/D

Command

Name

Description

AT$I=uint

Information

Display various product information:

0: Software Name & Version

Example Response: AX-Sigfox 1.0.6-ETSI

1: Contact Details

Example Response: support@axsem.com

2: Silicon revision lower byte

Example Response: 8F

3: Silicon revision upper byte

Example Response: 00

4: Major Firmware Version

Example Response: 1

5: Minor Firmware Version

Example Response: 0

6: Firmware Revision

Example Response: 3

7: Firmware Variant (Frequency Band etc. (EU/US))

Example Response: ETSI

8: Firmware VCS Version

Example Response: v1.0.2-36

9: SIGFOX Library Version

Example Response: DL0-1.4

10: Device ID

Example Response: 00012345

11: PAC

Example Response: 0123456789ABCDEF

AT$P=uint

Set power mode

To conserve power, the AX-Sigfox can be put to sleep manually.

Depending on power mode, you will be responsible for waking up

the AX-Sigfox again!

0: software reset (settings will be reset to values in flash)

1: sleep (send a break to wake up)

2: deep sleep (toggle GPIO9 or RESET_N pin to wake up; the AX-

Sigfox is not running and all settings will be reset!)

AT$WR

Save config

Write all settings to flash (RX/TX frequencies, registers) so that

they survive reset/deep sleep or loss of power.

Use AT$P=0 to reset the AX-Sigfox and load settings from flash.

AX-SIGFOX Datasheet(PDF) 21 Page - ON Semiconductor

AX-SIGFOX Datasheet(HTML) 21 Page - ON Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Datasheet Download

Link URL