ATmega16 datasheet(293/315 Pages) ATMEL

293 / 315 page

293

ATmega16(L)

2466E–AVR–10/02

ATmega16 Typical Characteristics – Preliminary Data

The following charts show typical behavior. These figures are not tested during manu-

facturing. All current consumption measurements are performed with all I/O pins

configured as inputs and with internal pull-ups enabled. A sine wave generator with rail-

to-rail output is used as clock source.

The power consumption in Power-down mode is independent of clock selection.

The current consumption is a function of several factors such as: operating voltage,

operating frequency, loading of I/O pins, switching rate of I/O pins, code executed and

ambient temperature. The dominating factors are operating voltage and frequency.

The current drawn from capacitive loaded pins may be estimated (for one pin) as

L*VCC*f where CL = load capacitance, VCC = operating voltage and f = average switch-

ing frequency of I/O pin.

The parts are characterized at frequencies higher than test limits. Parts are not guaran-

teed to function properly at frequencies higher than the ordering code indicates.

The difference between current consumption in Power-down mode with Watchdog

Timer enabled and Power-down mode with Watchdog Timer disabled represents the dif-

ferential current drawn by the Watchdog Timer.

ATMEGA16 Datasheet(PDF) 293 Page - ATMEL Corporation